Xblitz Spirit 2, Руководство пользователя

Страница: 9 / 68

9
04. DISPLAY
The following are the messages that may appear on the display and their meaning.
1. Message : „C”
Meaning: Gas detected, please continue to blow
2. Message : „-”
Meaning Analysis in progress, please wait
3. Message : „Err”
Meaning: Sensor malfunction
4. Message : „rP”
Meaning Unstable exhalation or interrupted exhalation
5. Message : „blo”
Meaning: Start blowing into the mouthpiece of the device
6. Message : „Lob”
Meaning : Low battery level
05. OPERATION OF THE DEVICE
1. Remove the battery box cover on the back of the unit and place two 1.5V AA
batteries inside. Make sure the battery terminals are facing the correct way
and reattach the container cover.
2. Fit the mouthpiece to the side so that it is at 90 degrees to the rest of the
device.
3. To start the device, hold down the button on the device for approximately
2 seconds. A beep will sound from the device, the LED will light up blue and
the display will show a countdown from 20 to 0. Wait until the countdown
has finished to ensure that the device sensor is ready for use.
NOTE: Do not blow into the mouthpiece until the countdown is complete.
Premature use of the device may lead to an incorrect measurement of the
breath alcohol content.
4. When the countdown is over, the display will show “blo”. Take a deep breath
and start blowing into the mouthpiece. The display will show a string of
letters “C”, continue blowing until a beep sounds from the device. After a
few seconds, the measurement result will appear on the display. The result
of the measurement is given in per mille (blood alcohol content).
NOTE: If the exhaled air flow is not constant or is interrupted during the
measurement, the display will show “rP”.
5. If the measured blood alcohol level is below 0.2 ‰, the LED under the
display will light up green. If the measured blood alcohol level is above 0.2
‰, the LED will light up red and an alarm will sound from the device.
6. If you want to manually switch off the device, hold down the button for 3
seconds. The device will switch off spontaneously a few tens of seconds after
the last activity.
7. To change the unit of the result after the measurement is finished, press the