AR396 User’s Guide
51
Global Setting
Set
the
AP mode
as Access Point or Wireless Bridge
When
the
AP mode
is set to Wireless Bridge, the
Wireless Restrict
determine where it can
communicate with all other wireless bridges (set
Bridge Restrict
is Disabled) or just the
specified MAC addresses of remote wireless bridge devices (set
Bridge Restrict
is Enable
or Enable (scan)).
Click Refresh to get the updated information
Click
Save/Apply
to save the configuration
Advanced
This page allows you to configure advanced parameters for wireless communication.
Figure 78: Wireless Setting – Advanced
Global Setting
Enable
AP Isolation
if you do not want AP to be able to communicate with each other.
Set the W
ireless Communication Band
. If you do not know it, please it as default.
Select
the
channel
from the list
Enter the value of
Auto Channel Timer
Set
the
54g Rate
(Wireless Communication Rate), AUTO means to use the highest rate if
possible)
Set
the
Rate for Multicast Packets
, AUTO means to use the highest if possible.
Set
the
Basic Rate
Set
the
Fragmentation Threshold
values from 256 to 2364 bytes. If the value is too small,
it may cause a result in poor performance.
Set
the
RTS (Ready to Send) Threshold
Set
DTIM Interval.
DTIM stands for Delivery Traffic Indication Message. This is a beacon
and is a countdown informing wireless clients of the next window for listening to broadcast
and multicast messages. It is a wake-up interval for clients in power-saving mode.
Set
Beacon Interval
. The interval in milliseconds between beacon transmissions.
