by pressing the shift/custom button. You
can add steps during playback by pressing and
holding the shift/custom button, and then
choosing steps to be added at the end of the cus-
tom sequence. When the custom sequence is
inactive adding new steps erases the previous
custom sequence. To erase the custom se-
quence without replacing it with a new one,
press transport + shift.
PRESETS
Pressing and holding the patt/preset but-
ton for one second enterss the preset memory.
This mode is indicated by a red LED next to
the patt/preset button. There are 8 preset
slots available. A written slot is indicated by a
green backlight. To choose a preset, push the
corresponding step button. Upon loading the
preset its step button flickers, and the back-
light changes from green to red. The last load-
ed preset is indicated by a red backlight on the
corresponding step/slot. Patterns saved while
two Moskwa II units were chained together
(see: below) are indicated by a yellow back-
light. Loading such a chained pattern switches
the units to chain mode.
To write a new preset (saving the current state
of the module), enter the preset memory by
pressing and holding the patt/preset but-
ton for one second. Press and hold the shift
button, and then press the step button to which
you want to assign the preset. All settings are
written along with the preset except for the cv
lock function (see: “Global Settings”). Loading
a preset may lead to discrepancies between the
values set by the knobs and the actual values gen-
erated by the loaded preset. To avoid unexpect-
ed pitch jumps after touching a knob, the value
changes only when you move the knob past the
value written with the preset. To recall the cur-
rent knob positions, load an empty preset slot.
TRANSPORT BUTTON:
SECONDARy fUNCTIONS
The transport button can be used to restore
default settings when combined with the indi-
vidual sequence step 1-8 buttons or the main
mode buttons step and patt. In step mode,
transport + step 1-8 resets all settings for
the chosen step, while transport + step re-
sets all steps’ settings from step mode (includ-
ing the deactivation of steps). In pattern mode,
transport + step 1-8 clears the pattern for
the chosen step, while transport + patt re-
sets all the settings from pattern mode. In pre-
set mode, transport + step 1-8 clears the
chosen preset slot.
With step 3 active in the global settings
(see: below), pushing the transport button
and turning the probability knob all the way
clockwise and then all the way counterclockwise
clears the probability sequence (see: below).
In step mode, press transport + shift/cus-
tom to erase the custom sequence.
STEP SETTINgS
To edit a step, push and hold its button for one
second. Editing multiple steps simultaneously
is possible by pressing and holding the first one
while pressing each additional step to be edit-
ed. The chosen steps light up green. The step
1-8 buttons are used to select various functions
marked on the panel. When a function is select-
ed its button lights up green.
step 1 • slew on button activates/deactivates
the slew limiter for the chosen step. The length
of the slew is adjusted globally for all steps with
the slew knob.
step 2 • slew prob button activates/deacti-
vates the probability of the inversion of the slew
7
