Xantrex Xanbus System, Руководство пользователя

Страница: 18 / 50

10 Xanbus System Control Panel (SCP) Owner’s Guide
Xanbus System Control Panel Installation
Connecting Xanbus Cables
Follow these guidelines for connecting Xanbus cables to the SCP. The
cables are connected to the SCP at the same time the SCP is mounted. Read
“Mounting the System Control Panel” on page 11 before performing the
following procedures.
To connect Xanbus cables to the SCP:
1. Connect the Xanbus cable (or two Xanbus cables, if the SCP is located
between two Xanbus-enabled devices) to a Xanbus network input in
the SCP.
2. Route and connect the cable(s) to the nearest Xanbus-enabled
device(s).
3. For additional devices, continue connecting cable as described above.
4. Ensure that male network terminators are inserted into the empty
inputs in the Xanbus-enabled devices at the beginning and end of the
network. When the network is completely connected, there should be
no empty network inputs in any Xanbus-enabled device. See Figure 3
on page 6.
EQUIPMENT DAMAGE
• Connect the SCP only to other Xanbus-enabled devices.
• Although the cabling and connectors used in this network system are
the same as Ethernet connectors, this network is not an Ethernet
system. Equipment damage may result from connecting a Xanbus
system directly to a personal computer.
• Do not connect one end of the network to the other to make a ring or
loop.
Failure to follow these instructions can damage the unit and/or
damage other equipment.