Xantrex RC7 - REV 1, Инструкция по установке и эксплуатации

Страница: 18 / 48

RC7 & RC7GS Remote Controls
3.0 OPERATION
12
6. Set Shore Power
The inverter monitors the AC power being drawn by both the battery
charger and the AC loads connected to the inverter. If the current draw ap-
proaches the shorepower circuit breaker rating, the battery charger reduces the
amount of current supplied to the batteries to provide the maximum current to
the AC loads. Set Shore Power ensures the battery charger does not exceed the
shorepower circuit breaker rating. This setting should match the shorepower or
generator’s circuit breaker rating. The default setting is 30 amps.
Figure 18
Set Shore Power Selections
7. RC7 Setup
The RC7 LCD screen displays system status and error messages that
occur during normal operation. From the Setup menu select:
Last Key (default) to display the last system status message displayed after
exiting the Setup menu.
Rolling Display to automatically show system status, state-of-charge, time
left to run, time left to charge, set shore power and gen start/stop (RC7GS only).
Power Saver to shut off the LCD display and LEDs after five minutes
without a key-press or new error message. Pressing any key will reactivate the
LCD display and LEDs for another five minutes. Errors during the power saver
mode will “wake-up” the remote.
RC7 Setup:
Last Key RC7 Setup:
Power Saver RC7 Setup:
Rolling Display
Set Shore Power
30 Amps
Set Shore Power
25 Amps
Set Shore Power
20 Amps
Set Shore Power
5 Amps
Set Shore Power
15 Amps
Set Shore Power
10 Amps
Figure 19
Set Shore Power Selections