Xantrex Freedom X 1200, Руководство пользователя

Страница: 45 / 100

Basic Installation Procedures
975-0767-01-01 43
There are three kinds of AC Output Connections. These are:
l
Connecting to an existing permanent AC output
circuit
. Follow the instructions on AC Output Connections
on page 43 and finish the installation there in that section.
l
Installing a GFCI receptacle only without connecting to
an existing permanent AC output circuit
. Follow the
instructions on GFCI Connections on page 45 and finish the
installation there in that section.
l
Installing a GFCI receptacle and also connecting to an
existing permanent AC output circuit
. Follow the
instructions on GFCI with AC Output Wiring Connections on
page 48 and finish the installation there in that section.
AC Output Connections
Figure 10 Routing and connecting the AC output wires
L G N
L G
N
N L G N L G
2
1
3
4
5
1 step 7a 4 15mm
2 step 7b 5 to circuit breaker
3 step 7c
NOTE : AC Output hole - install a strain
relief clamp (not shown)
To make a permanent connection to existing AC wiring:
1. Ensure AC and DC power sources are turned off, if not
already done from AC Input Connections on page 40 .
2. Install the required circuit breaker in the inverter distribution
panel receiving AC power from the inverter.
3. Remove the wiring compartment cover, if not already done
from AC Input Connections on page 40 .