Xantrex Freedom X 1200, Руководство пользователя

Страница: 42 / 100

Basic Installation Procedures
40 Freedom X 1200 Owner's Guide
AC Input Connections
To make a permanent connection to existing AC wiring:
1. Ensure AC and DC power sources are turned off.
2. Install the required circuit breaker in the AC distribution
panel supplying AC power to the unit.
3. Remove the wiring compartment cover by loosening the
captive nut panel screw and lifting the cover up and out.
WARNING
ELECTRIC SHOCK HAZARD
Use a screwdriver to loosen the captive nut panel screw.
Failure to follow these instructions can result in death, serious
injury, or equipment damage
.
Figure 8 Loosening the captive nut panel screw
1
1 Captive nut panel screw
4. Strip a single AC input wire, as appropriate. Strip 15 mm off
the ends of each of the three the wires (tin the exposed
copper wire with lead-free solder using a soldering iron).
5. Remove the knockout and install a ½" strain relief clamp.
6. Route the wires through the strain relief clamp (not shown in
the figure).
Figure 9 Routing the AC input wires
L
G
N
NG
L
N L G N L G
2
1
3
4
5
1 step 8a 4 15mm
2 step 8b 5 to circuit breaker
3 step 8c
NOTE : AC Input hole - install a strain
relief clamp (not shown)
7. Locate the Neutral, Ground and Line terminals on the AC
input terminal labeled as N , G , and L respectively.