Xantrex ALM - REV A, Руководство пользователя, Страница: 11 / 36

7
©2001 Xantrex Technology Inc.
P/N 975-0027-01-01 Rev A 09/01
6-9/64
4-27/32
19/32
3-11/16
4-7/8
19/32
J1
SW1
SW2
1-13/64
Figure 2-1
Dimensional Drawing (Not to Scale)
The ALM is required to be installed in a clean, dry, protected environment and
should be mounted close to the load in a location where it is easily accessible. Dual
knockouts, in the sizes of ½, ¾ and 1 inch, are provided for cable routing and
conduit connections. Mount the ALM to a flat, vertical surface, such as a wall.
Tools Required
screwdrivers (Phillips and flat blade) wood screws (#10)
drill and assorted bits anchors (if required)
wire strippers
WARNING: BEFORE MAKING ANY CONNECTIONS
TO THE LOAD OR INVERTER, ENSURE THAT ALL AC
AND DC POWER IS DISCONNECTED FROM THE
INVERTER AND THE ALM.
Pre-Installation
Before installing the ALM, read all instructions and cautionary markings
located in this manual.
Determine the wire route (or conduit runs) to the ALM and loads.
NOTE: Check for existing electrical, plumbing, or other
potential areas of accidental damage prior to making cuts
in structural surfaces.
2.0 INSTALLATION