2
Xantrex Gateway Getting Started
Product Safety Information
NOTICE
RISK OF ELECTRIC SHOCK AND EQUIPMENT DAMAGE
n
Do not expose the Gateway Touchscreen to rain, snow, spray, or bilge water. For indoor use
only.
n
Do not disassemble. No user serviceable parts inside.
n
Do not install and/or operate in compartments containing flammable materials or in locations that
require ignition-protected equipment.
Failure to follow these instructions may result in injury or equipment damage.
EMI Information
This device complies with part 15 of the FCC Rules and contains a licence-exempt transceiver that complies
with ISED Canada’s licence-exempt RSS Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation.
These limits are designed to provide reasonable protection against harmful interference in a residential
environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
c
CAUTION
Unauthorized changes or modifications to the equipment could void the user’s authority to operate the
equipment.
c
This prototype device is currently undergoing testing in compliance with the CE Marking Radio Equipment
Directive for RF spectrum and RF safety as well as the EMC Directive for emissions and immunity
requirements. Regulatory approval pending.
Getting started
1
Inspect the package and make sure you have
the following materials:
a. Touchscreen device
b. HDMI cable (to provide communication)
c. USB cable (to connect to a power source)
2
Using the USB cable, connect the cable to
the micro-USB port on the Touchscreen
and to one of the USB-A ports on the
Xantrex Gateway.
3
Using the HDMI cable, connect the cable
to the HDMI port on the Touchscreen and
to the HDMI port on the Xantrex Gateway.
4
Follow the instructions on the Touchscreen
to operate and monitor all connected
devices to the Xantrex Gateway including
the Gateway itself.
2
3
Use the strain-relief zip ties
to fasten the cable and the
connector firmly to the port.
