27
EN
How to use
CO2 cylinder installation:
1. Take out the Soda Maker and CO2 cylinder.
2. Invert the Soda Maker on a flat, sturdy surface.
3. Remove seal and cap from the CO2 cylinder. Insert the CO2 cylinder into the opening of the cylinder
hollow at the base of the Soda Maker and turn the CO2 cylinder clockwise while applying gentle pressure
until it is firmly held in place. Hand-tighten only; do not use tools.
4. Place your Soda Maker back in the upright position. You are ready to create the bubbles.
Turn Water Into Soda in Seconds:
1. Fill water to the line indicated by the iconic facet and wave design. Cold water absorbs and holds carbo-
nation better than ambient temperature water. For best-tasting results and maximum carbonator yield,
refrigerate water before carbonation.
2. Insert the carbonating bottle neck into the Snap-lock. Turn the bottle clockwise. The Snap-lock mecha-
nism will catch the bottle and hold it in a vertical position. Make sure that the bottle neck into the Snap-
lock.
3. Push down the carbonating block, hold for 1-2 seconds and release. Repeat to obtain stronger levels of
carbonation. (See Carbonating Level section)
4. When the desired level of carbonation is achieved, push down the release button, hold for 1-2 seconds.
Repeat and make sure no pressure in the bottle before taking the bottle out.
5. Remove the bottle from the Snap-lock counter-clockwise.
You are now ready to taste the perfect sparkling beverage, prepared expressly by YOU!