7
8
CONNECTING TO THE GATEWAY ///
DISCOVERING NEW DEVICES
In order for the Gateway to control
devices such as cameras, thermostats and switches,
each device must be registered with the Gateway. The Gateway establishes a “secure wireless network”
between itself and all discovered devices. The Gateway can only control devices that it has discovered.
New devices can be discovered at any time.
In order for the Gateway and its associated devices to be used, it must be configured first and
the devices it controls must be discovered. All configuration and discovery is performed through
the Gateway local administration pages. To get to these pages you must log on to the Gateway
using your browser. Please refer to your User Manual for Gateway configuration information.
Once configured, a setup wizard will be presented.
When you get to Step #4 of the setup wizard, press the discovery button on the devices you wish to
discover at this time. Click the ‘NEXT’ button when you have completed discovering your devices.
NOTE:
This page will automatically refresh every 15 seconds to display newly discovered devices.
It will also automatically stop discovering devices after 15 minutes. You will be able to discover
devices at a later time if you choose to do so.
SETUP WIZARD
- DEVICE DISCOVERY START PAGE
SETUP WIZARD
- DEVICE DISCOVERY DEVICE SETUP PAGE
OPERATIONAL MODES ///
OFF
The Heating and Cooling systems are both off and do not respond to any changes in
temperature settings.
HEAT
The Heating system activates to maintain desired heating setting. The Heating system will
be turned on at one degree Fahrenheit (approximately 5ºC) below the set point and will turn off
at the set point.
COOL
The Cooling system activates to maintain desired cooling setting. The Cooling system will
be turned on at one degree Fahrenheit (approximately 5ºC) above the set point and will turn off
at the set point.
AUTO
The
Thermostat
will automatically switch between heat and cool modes to maintain the desired
heating and cooling temperature settings. To ensure that the heating and air conditioning systems
are not activated simultaneously, the system has a built-in offset. This offset maintains a minimum
of three degrees Fahrenheit or Celsius between the desired heat and cool temperatures. If you try
to change one temperature set point within three degrees of the other temperature set point, the
Thermostat
will automatically adjust the other set point to ensure the offset is maintained.
For example, if you have the heat set to a desired temperature of 69ºF and you attempt to set the
desired cooling temperature to 71ºF, the desired heating temperature will automatically decrease to
68ºF to maintain the 3ºF difference.
The AUTO mode automatically turns the Heating or AC on, based on the temperature ranges you
entered for Cool and Heat. However, the first time the
Thermostat
changes the operating mode from
heat to cool or from cool to heat, the temperature must rise two degrees above the set point for the
change to occur. This keeps your HVAC system from overshooting and constantly alternating between
the heater and air conditioner.
MANUAL CONTROL BUTTONS ///
TEMPERATURE UP BUTTON
Adjust the Current Schedule Temperature to a higher value
TEMPERATURE DOWN BUTTON
Adjust the Current Schedule Temperature to a lower value
MODE BUTTON
Select a Mode you want to change
ENTER BUTTON
Activate the selected Mode
Содержание XWT380
Страница 1: ...THERMOSTAT v1 0 ...
