X10 WM100, Руководство по эксплуатации продукта

Страница: 18 / 20

App - Setup 18 Model WM100
App – Setup
o
General Settings

Adjust Time of HUB
•
If you find that the timing of your HUB is off, or is not turning devices on
and off at the right times, you may want to adjust the time of the HUB.
• Select the Setup tab > General settings > Adjust time of the WiFi HUB >
Sync HUB time with this device.
• This will sync the HUB with the device you are currently using.

Check for Firmware Update
•
The APP will normally let you know if there is a new firmware available,
but you can also manually check.
• Select the Setup tab > General settings > Check for firmware update.
•
If an update is available, it will ask you if wish to update and it will take a
few minutes to do so. Try to keep the device awake to avoid the device
potentially going into sleep mode, disturbing the update process.
o
X10 WiFi History and Settings

X10 Communication History
• This screen shows the last 50 Commands the WM100 has heard over
your power line. These are not just signals sent and received from the
WM100, but are any X10 signal that is found on the line.
• You can also see the Firmware Version, Assigned IP Address and the
Port used by your router for the WM100.
•
Clear History
o
If you would like to clear the history, simply hit this button to do
so.
o
Sync Data from HUB

Hitting this button will sync your Apps data with the WM100. This is useful if,
for instance, you have made changes from another device and they have not yet
showed up on your current device.
o
Enter WiFi setup Wizard

This will enter the WiFi setup and allow you to change the network the WM100
is connected to or the routers password if necessary.
o
Reset to Factory Settings

This option will reset all the data on your APP ONLY. This does not affect the
WM100. This will simply clear out the data on your phone. If the WM100 does
not receive a hardware reset, once you reconnect with the WM100 it will resync
the App and download the information and settings from your WM100.

To completely remove all data from both the hardware (WM100) and the App,
do a hard reset on the WM100 itself.
• To do this, HOLD down the SYNC button for about 10-15 seconds. You
will see a slow blink after about 4 -5 seconds then around 10-15 seconds