X10 SoundPower VK59A, Руководство пользователя

Страница: 6 / 15

1 1 1 1 1 1 1 1 1 1 1 0 1 0 1 0 1 0 1 0
TTTTT
HE HE HE HE HE
UR78A R UR78A R
UR78A R UR78A R
UR78A R
EMOTE EMOTE EMOTE EMOTE EMOTE
The UR78A Remote lets you control practically every audio/video
product in your home. It has IR technology that lets you control your
TV, VCR, Cable and CD or DVD player, and RF technology that lets
you control the VR32A wireless receiver/speaker driver. This lets
you control, the volume, balance, bass, treble, etc. of the speakers
connected to the VR32A from anywhere inside or outside your home.
It can also control an MP3, DVD, and CD player in your PC when
used with an additional RF receiver and software (see page 17).
IIIII
NST NST NST NST NSTALLING ALLING ALLING ALLING ALLING THE THE THE THE THE BA BA BA BA BATTERIES TTERIES TTERIES TTERIES TTERIES
1. 1. 1. 1. 1. Push the tab and lift off the battery cover.
2. 2. 2. 2. 2. Insert four AAA alkaline batteries, taking
care to match the + and - marks in the
battery compartment.
B BB BB
A A A A ATTER TTER TTER TTER TTERY YY YY
S S S S S
A A A A AVER VER VER VER VER
Your UR78A remote will automatically “time-out” if the keys are
depressed for more than two minutes. This will save your batteries
should your remote get stuck in a place where the keys remain
depressed (e.g., between the sofa cushions).
C CC
C C
ODE ODE
ODE ODE
ODE
S S
S S S
A A
A A
AVER VER
VER VER
VER
(I (I
(I (I (I
MPOR MPOR
MPOR MPOR
MPORTTTTTANT ANT
ANT ANT
ANT
)))))
You will have up to 90 seconds to change the batteries in your
remote without losing codes you have programmed. However, do not
press any buttons until batteries are installed in the remote. If buttons
are pressed without batteries in the remote, all codes will be lost.
IIIII
FFFFF YOU YOU YOU YOU YOU ARE ARE ARE ARE ARE NOT NOT NOT NOT NOT GETTING GETTING GETTING GETTING GETTING ANY ANY ANY ANY ANY SIGNAL SIGNAL SIGNAL SIGNAL SIGNAL A A A A ATTTTT ALL ALL ALL ALL ALL
Check that the CHANNEL slide switch (labeled A, B, C, D) on both
units is set to the same letter.
IIIII
FFFFF THE THE
THE THE THE
SIGNAL SIGNAL
SIGNAL SIGNAL SIGNAL
IS IS
IS IS IS
POOR POOR
POOR POOR POOR
, , , , ,
OR OR
OR OR OR
THERE THERE
THERE THERE THERE
IS IS
IS IS IS
INTERFERENCE INTERFERENCE
INTERFERENCE INTERFERENCE INTERFERENCE
Try changing the channel on both units. Do this by adjusting the
CHANNEL slide switch on each unit to any position from A to C.
Make sure both units are set to the same channel.
F F
F F
F
INE INE INE INE INE
T T
T T
T
UNING UNING UNING UNING UNING YOUR YOUR YOUR YOUR YOUR
S S
S S
S
YSTEM YSTEM YSTEM YSTEM YSTEM
The Wireless Audio Sender usually works best with the flat faces of
the antennas on the Sender and Receiver units facing each other (i.e.
in “Line of sight” - see diagram below). Sometimes, however,
reflections and other effects in your home may affect the signal so
that some adjustment of either the Sender or Receiver antenna might
be necessary to get the best signal.