4. Use the menu buttons UP/DOWN?
to go to menu item
4. MESSAGE
. Press OK to select this menu item. You can
also go to this menu item directly by pressing a 4 on the number pad.
5. Press 1 for
RECORD
.
6. The display now shows
PLEASE WAIT.
7. When the display reads
SPEAK NOW
you can record your message (max. 12 seconds). The distance to the
microphone should be more or less around 30 cm.
8. After recording, wait until the
RECORD/REPLAY
option comes up again.
9. Press 2 (REPLAY) to listen to the recorded message.
10. Press CLEAR to quit the menu. To confirm this choice, press 1 for Yes or 2 for No. If you choose Yes, you
will quit the menu. If you choose No, you go back to the first menu item.
6. Using the Pr Security System
6.1 Setting the alarm
The system has two different alarm functions:
1)
ARM AWAY
: Full alarm. All registered Sensors will be activated.
2)
ARM HOME
: Partial alarm. All Door/Window sensors will be activated, but the motion detectors are not
armed. This means you can walk around the house, while the ‘shell’ of is protected.
a) A
single
press arms all Door/Window Sensors
b) A
double
press of ARM HOME results in every sensor to be active in zones 1-16 but motion
detectors are still not active in zones 17-30. All Door/Window Sensors are however active in zones
17-30.
+Switching on the ARM AWAY function
Via the console
Press the ARM AWAY button on the console. The system will be activated after a short delay (delay can be set,
see exit delay 8.1). During the delay you will hear a couple of tones at the same pitch, and the display will read
EXIT DELAY
.
After switching the system to
ARMED AWAY
mode, the entry delay will be used for DS18 Door/Window Sensors
(DS18 switch set to MAX) when you enter the house. This means you have enough time to switch off the system
via the console without triggering the alarm. The delay times can be changed, see 8.1.
Also Motion Sensors registered to zone 15 and/or 16 will have an entrance delay according the time set. This
gives the opportunity to have entrances secured via Motion Sensors.
Besides the Security function, the
ARM AWAY
button on the console reflects Temperature Setback options, to
be used for energy saving:
Press the
ARM AWAY
button on the console. The system will be activated after a short delay:
-A
single
press: Thermostat remains setting of respective TS10. Display will show
COMFORT.
-Press
twice
; thermostat level will be set to Economy Level. Display will show
ECONOMY.
-
Third
press: thermostat level will be set to Frost Level. Display will show
FROST
.
The first press of ARM AWAY will leave the thermostat working exactly as it would do if the system was not
armed i.e. it will follow the set-point on the thermostat(s) unless there is a timer event set which could change it.
Via the Key Chain Remote Control KR18
Press the ARM button. The alarm is switched on instantly.
Via the Comfort Remote Control SH600
Set the slide switch to SEC. Press the ARM AWAY button. The alarm is switched on instantly.
+Switching on the ARM HOME function
Via the console
Press the ARM HOME button on the console. The alarm is switched on instantly.
-A
single
press arms all Door/Window Sensors. Display will read
ARM HOME 1
.
-A
double
press of ARM HOME actives all Sensors in zones 1-16. Display will read
ARM HOME 2
.
Via the Key Chain Remote Control KR18
You cannot switch on the ARM HOME function with this remote control.
Via the Comfort Remote Control SH600
Set the slide switch to SEC. Press the ARM HOME button. The alarm is switched on instantly.
