X10 MK19A, Руководство пользователя

Страница: 20 / 27

3 9 3 9 3 9 3 9 3 9 3 8 3 8 3 8 3 8 3 8
I I I I I
NST NST NST NST NSTALLING ALLING ALLING ALLING ALLING
H H
H H H
OME OME OME OME OME
A A
A A A
UTOMA UTOMA UTOMA UTOMA UTOMATION TION TION TION TION
CCCCC
OMPONENTS OMPONENTS OMPONENTS OMPONENTS OMPONENTS
TTTTT
RANSCEIVER RANSCEIVER RANSCEIVER RANSCEIVER RANSCEIVER
M M
M M
M
ODULE ODULE ODULE ODULE ODULE
The Transceiver Module (sold separately)
receives radio frequency (RF) commands
from Mouse Remote to operate a lamp
or appliance plugged into it. The
Transceiver Module also passes on
commands over your house wiring to
control other X10 Modules. Note that
(unlike the Lamp Module) you cannot
dim and brighten a lamp connected to
the Transceiver Module.
You should locate the Transceiver
Module centrally in the home for
maximum range when controlled by the
X10 Mouse Remote.
1. 1.
1. 1.
1. Set the House Code
to ‘A’ .
2. 2.
2. 2. 2. Plug a lamp or
appliance into the
Transceiver
Module.
3. 3.
3. 3. 3. Plug the Transceiver
Module into a
convenient AC
outlet. Fully extend
the antenna.
UNIT CODE
DIAL
HOUSE CODE
DIAL
H H H H H
OUSE OUSE
OUSE OUSE
OUSE
C C C C C
ODES ODES
ODES ODES
ODES AND AND
AND AND
AND
U U U U U
NIT NIT
NIT NIT
NIT
C C C C C
ODES ODES
ODES ODES
ODES
Each Module has a specific address
made up of a House Code (red dial on
the face of the Module) and a Unit Code
(black dial on the face of the Module).
The Controller first sends an address and
then a command on the AC power lines.
Only the Module with a matching
address will execute the command. If
more than one Module has the same
address, both Modules will execute the
command.
Addresses are set on the Module by
turning the two dials on the front of the
Module to the desired letter and number
(using a small screwdriver or a coin). The
House Code is selected from the letters A
through P, and the Unit Code is selected
from the numbers 1 through 16.