X10 IconRemote IR27A, Руководство пользователя

Страница: 9 / 26

17 16
Setting Up X10 Devices, cont.
In the following example we’ll set up the remote for a LM465
Lamp Module located in the
“Basement.”
•
Press the HOME key to display the setup screen. Select
Setup .
•
Select Devices at the new screen.
•
At the Device screen, select X10 .
•
Select Add/Edit at the next screen.
•
Select Basement (for this example).
•
Press OK on the remote to continue.
•
Select Address .
•
Use the side buttons to set the values
to
B3 .
•
Note: The values in the Address
screen must match the physical
hardware settings for the LM465
Lamp Module. In this example, the
settings are set at B3. This means
that B3 matches the physical settings
at the Lamp Module. (See the
following example on how to set up a Lamp Module for a
B3 setting.)
•
Press Save to save the values.
•
Select Pick Logo and choose an appropriate image.
•
Press Pick Device and go through the screens to select the
correct module.
•
Press Done .
When triggering an X10 module or wall switch from a remote
control, the signal is typically sent from the remote using RF
on a specific house code. (IR can also be used if you are using
an UX24A device.) The RF signal is received by the trans-
ceiver (either TM751, RR501, CM15A, or security console)
on the matching house code. The transceiver then forwards the
signal onto the house wiring. This is now a PLC signal. Any
modules that match the house and unit code transmitted will
either turn on or off, depending on the signal sent.
In the following example we’ll set up the remote for a TM751
Lamp Module using Housecode “B.”
•
Press the HOME key to display the setup screen. Select
Setup .
•
Select Devices at the new screen.
•
At the Device screen, select X10 .
•
Select Add/Edit at the next screen.
•
Choose the room where you will locate the TM751. For
this example choose
All Rooms .
•
At the add an X10 device screen, press OK .
•
Select Pick Device .
•
Select Appliances and then scroll until you see the TM751
icon. Select TM751 using the appropriate side-key.
•
At the following screen select
Address .
•
Using the side buttons, select “ B ”
but leave the bottom number to “1,”
making the address
B1 . (Note: All
transceiver devices must end in “1.”
•
Select Save using the side key.
•
The following screen will show the
TM751 icon. Select
Done using the
side key.
•
The Saving Settings screen appears.
Setting Up X10 Devices, cont.