23
How To Replace Controller
1.
Remove the Battery Pack from the scooter and set aside until new controller is installed.
2.
Open the seat and remove the four (4) seat barrel screws, two (2) near the Latch and two
(2)in Front.
3.
Remove entire Seat and Seat Barrel from scooter.
4.
Unscrew your old controller from the frame - Leave wires connected.
5.
Mount the New Controller in its location.
6.
Transfer One Connector at a time from the old controller to the new controller.
7.
Re-install Battery.
8.
With drive wheel Not touching any surface Test Run and confirm all functions are working.
9.
Re-assemble and test ride.
**This is also a good time to perform the recommended maintenance as listed in the Handbook.
How To Replace Rear Inner Tube
1.
Remove the seat and seat barrel. Four screws need to be removed, 2 by the hinge and 2 down
inside and remove from scooter.
2.
Follow the wire coming out of side of motor and cut the tie straps leading up the controller,
the box with lots of wires coming out of it, and unplug the motor wire.
3.
Remove the wheel nuts and remove the brake adjustment nut and remove the wheel.
4.
Let all air out of tire and use either a tire wrench or couple dull screw drivers to remove tire
bead from one side of rim to remove and install the tube.
5.
Install in reverse order make sure that the motor nuts are on extremely tight, use a 2 1/2'
crescent wrench to tighten them.
How to Remove Hub Motor
1.
Remove the two nuts on each side of the motor.
2.
Remove brake adjustment nut and remove brake cable from brake hub.
3.
Remove brake hub lock nut where it attaches to frame.
4.
Remove axle lock plate by removing the #10 bolt on each side.
5.
Follow the motor wires up under the rear fender, it will connect to quick disconnects and
unplug the cables.
6.
Follow the chain up to the pedal sprocket and move the chain off of sprocket. Use the pedals
to turn until the chain is totally off of the sprocket. Then remove the sprocket off of wheel
sprocket.
7.
Remove wheel motor from scooter.
How To Replace Throttle
1.
Remove six Phillips head screws from handlebar cover.
2.
Unplug six pin and one pin connectors from instrument panel.
Содержание XB-700Li
Страница 7: ...7 Product features ...
