14
ASSEMBLY AND SETUP
1) Remove your XB-420M from its shipping carton. The
XB-420M weighs about 150 lbs, so get help, and use care.
Cut away any residual packing materials with a knife or
scissors. Tools needed for setup are included in the XB-
420M tool kit.
2) Attach the front wheel:
a.
Place a support under the floor board
section to raise the front of the scooter just
enough to easily install the front wheel.
b.
Remove the nut on the axle bolt.
c.
Slide out the axle bolt and spacer.
d.
Slide the brake assembly (that is hanging
down) into the wheel cavity.
e.
Position the wheel between the forks with
the spacer on the side of the wheel that
does not contain the brake assembly.
f.
Slide the axle bolt back in, this time through
the center of the wheel.
g.
Tighten the nut on the axle bolt and insert
the cotter (safety) pin.
h.
Inflate the front and rear tires to 35 psi.
3) To make sure the alignment is correct, stand in front
of the vehicle, using both legs to hold the front wheel in a
straight-forward position. Use both hands to grab the
handle bar and turn it into normal driving position (90
degree angle from the front wheel).
4) Attach the Rear View Mirrors to the mounting holes. A
wrench can be used to tighten the lock nuts at the base
of each mirror.
