X-TREME X-250, Руководство пользователя

Страница: 24 / 30

Page24
F) Wires behind fuse assembly have come off due to improper replacement of fuses or
loose wire connections to the battery. This is always due to the customer rotating the
whole fuse assembly (when changing fuses) and twisting the 2 wires that are in the back
of the fuse holder. You must open up scooter and reattach these wires to back of fuse
assembly or to battery and control box. If this is the problem the lights WILL work when
you have the charger plugged in.
Troubleshooting: Scooter On, But Not Running
Follow the wire from the left handbrake down under the foot plate. Unplug this wire. There
is a safety in that brake that will not allow the motor to run when the brake is being applied.
Make sure the rear wheel is off of the ground, then try turning the throttle with this
Troubleshooting: Scooter Won’t Shut Off
Place the scooter off the ground so the rear wheel will not touch the ground. You do not
want your scooter to take off. Take the footplate off. Disconnect the throttle clip under the
footplate, then turn the scooter on and see if it still runs. If it does, you will need a new
controller.
Troubleshooting: Scooter Won’t Run, Charger Stays Green
When you plug your charger into your scooter and the wall outlet the charger light stays
green. This is telling me that somewhere between charger socket, controller, fuse holder
and batteries, you have an open circuit. Please remove the floor plate and check the wires
in this area. You may find a wire that is not connected, a connector that is not pushed
together properly or a fuse holder that is not letting the fuse connect properly.
Troubleshooting: Scooter Won’t Run, Charger Stays Red & Green
When you plug your charger into your scooter and the wall outlet the charger light stays
green. This is telling me that somewhere between the batteries, fuse, and charger socket
you have an open circuit. Please remove the floor plate and check the wires in this area.
You may find a wire that is not connected, a connector that is not pushed together properly
or a fuse holder that is not letting the fuse connect properly.