X-TREME X-250, Руководство пользователя

Страница: 20 / 30

Page20
12) Double check all nuts, bolts and cables.
13) With scooter on a box with the rear wheel Not touching any surface Test Run and
re-adjust Belt as needed.
How To Replace Inner Tube
1) Loosen the Pinch Nut on your brake hub to slide the Brake Cable out.
2) Remove the Axle Nuts and Chain Tensioners and Axle from the complete rear wheel.
3) Slide the Belt off of the Hub.
4) Remove the complete Rear Wheel.
5) Deflate Inner Tube completely.
6) Remove all four (4) of the hex bolts on the Hub and separate.
7) Replace the Inner Tube and put the Hubs back together with the four (4) Bolts.
Remember to put the Valve stem through the Hole on the Belt Drive Side.
8) Pump up tire and confirm that it is holding air.
9) Put the complete rear wheel back onto the frame and slide the Belt back onto the hub.
Verify that the Brake is fitting correctly as well.
10) Put the Axle back through the wheel hub and put adjust the tensioners so that the
wheel is centered. Tighten the Axle Nut.
11) Put the Brake Cable back through the pinch nut: adjust and tighten the nut.
12) double check all nuts, bolts and cables.
13) With scooter on a box with the rear wheel Not touching any surface Test Run and
re-adjust Belt as needed.
How To Test Batteries & Charger
Your X-250 is a 24 volt system. Check the battery wires, fuse holder wires, and the
charger socket wires, underneath the deck plate. Give each wire at the connection a firm
but gentle tug pulling away from the connection. Look for any loose, bare, blackened,
broken, or disconnected wires.
1. Check the wires at the rear of the charging socket
2. Check the wires at the rear of the fuse holder
3. Check all fuses
4. Check the wires that connect the batteries together
5. Check the connections on the controller
Battery voltmeter test: Please charge your batteries for eight hours then let them set for
one hour. After they have set check each battery with a digital voltmeter. Place the red
(positive) voltmeter probe on the red (positive) terminal on the battery, and place the black
(negative) voltmeter probe on the black or blue (negative) terminal on the battery. This will
give you a reading, per battery.