X-TREME X-140, Руководство пользователя

Страница: 24 / 29

Page24
4. Perform a test run with the rear wheel off of the ground.
5. If it does not run check the wires on the back side of the fuse socket for secure
connections. Check all other wire connections at this time.
How To Check Charger Output
Tools Needed
– Multi-meter set to DC voltage.
1) Determine the total DC voltage output of your scooter and set the multi-meter above
that amount.
2) Plug the charger into a 110v outlet, but do not plug it into the scooter.
3) Place the multi-meter probes into the holes to the left and right of the indented key on
the charger output side (connector that goes to the scooter).
****Attention: Do Not allow the two probes to touch each other while in the charger socket as it may
cause a short and/or spark.
This will give you the charger output reading to compare with what your scooter requires.
How To Install Bearings
1) Remove the rear/front wheel.
2) Remove the old bearing. To do this, you will need to insert something, like a screw
driver, from the opposite side and simply push it out.
3) Put the new bearings in. You will want to use something like a rubber mallet so you do
not crack the bearings. Set the wheel on a flat, absorbent surface, like a work bench. Tap
the bearing into the wheel evenly.
4) Re-install the tire and test ride.
How To Remove and Insert Pins In Connectors
1) Look down inside the connector; you will see a metal pin. The pin is held in place by a