If the chain is making a humming sound when the wheel is
turning, this is too tight and may cause the chain to snap.
The correct tension is achieved by adjusting the chain from its
loose position to when it becomes lightly tense.
To tighten the chains:
Slightly loosen the two axle bolts on both
sides of the rear wheel. (Fig.8). Then slowly
adjust the two adjusting screws on each side
of the rear tire (Fig.9) until chain reaches the
proper tension.
Rotate the rear wheel to make sure the chain
is aligned.
Finally, lock and tighten the rear axle bolts
prior to riding.
Fig. 8
Fig. 9
MAINTENANCE SCHEDULE
Proper care of your X-Treme X-360 will insure optimal performance and longer
life span. The following are a few maintenance suggestions that will keep your
X-Treme X-360 running in top condition:
Daily Maintenance
Perform each time you ride your X-360
Clean the exterior of the unit with a soft, damp rag. DO NOT
USE WATER TO CLEAN YOUR X-360.
Check that all nuts and bolts are securely tightened.
Lubricate the chain with any silicone spray, 3&1 oil or any good
clean motor oil.
Check battery charger for any frayed/cut wires.
Page11
