X-Stand X-SCAPE, Руководство по сборке и безопасному использованию, Страница: 13 / 16

FIGURE 1
FIGURE 2
FIGURE 3
FIGURE 4
FIGURE 5
FIGURE 6
FIGURE 7
Back
FIGURE 8
Back
FIGURE 9
Back
READ THIS MANUAL IN ITS ENTIRETY PRIOR TO USING THIS PRODUCT.
1
This instruction manual complies with the Treestand Manufacturers Association’s Standard Test Method for Treestand Fall Arrest Systems.
BACKPACKING INSTRUCTIONS
STEP 1. Take the top
(seat) section and lay flat
on the ground facing up.
Fold both seat section
supports out flat. (Fig. 1)
STEP 2. Then place
standing platform
directly on top of the
top (seat) section with
platform supports laying
out flat. (Fig. 2)
STEP 3. Pass the
backpack straps through
the top (seat) section just
behind the bark biter on
the inside of the welded
support tabs. (Fig. 3)
STEP 4. Fold
the right
standing
platform
supports flat while
tucking the cable under
the left platform support
folding it flat creating a
loop in the top of cable.
(Fig. 4)
STEP 5. Fold the left seat
section support flat while
tucking the cable under
the right seat support.
(Fig. 5) Creating a loop
in the top of cable. All
four supports should be
folded flat with cables
tucked underneath the
supports. (Fig. 6)
STEP 6.
Locate the elastic
ropes (with ball ends)
attached to the top seat
supports. (Fig. 7)
STEP 7.
Pull the ball ends
of the elastic ropes tight
and push them through
the top (seat) section right
behind the bark biter on
the inside of
the welded
tabs. ( Pass
ball ends
through the
same area as
backpack straps) (Fig. 8)
Note
The ball ends will
lock into the triangle
shaped part of the frame
Securing the folded
supports.
STEP 8.
Turn the stand
over and connect the
male end of the backpack
straps to the female end
of the backpack straps.
(Fig. 9)