x-sense SC03, Руководство пользователя

Страница: 23 / 56

† 
WARNING!
1. NEVER USE AN OPEN FLAME OF ANY KIND TO TEST THIS UNIT. YOU MIGHT
ACCIDENTALLY DAMAGE OR SET FIRE TO THE UNIT OR TO YOUR HOME.
2. NEVER USE A VEHICLE EXHAUST TO TEST THIS UNIT. EXHAUST FUMES MAY
CAUSE PERMANENT DAMAGE AND VOID YOUR WARRANTY.
3. DO NOT STAND CLOSE TO THE ALARM WHEN THE ALARM IS SOUNDING.
EXPOSURE AT CLOSE RANGE MAY BE HARMFUL TO YOUR HEARING. WHEN
TESTING, STEP AWAY WHEN THE ALARM BEGINS TO SOUND.
­
To keep your smoke/CO alarm in good working order, follow these simple steps:
1. Verify the unit's alarm sound and indicators are working properly by testing the
unit once a week.
2. Remove the unit from the ceiling/wall and clean the alarm cover and vents with a
soft brush attachment once a month to remove dust and dirt.
3. Never use detergents or other solvents to clean the unit.
4. Avoid spraying air fresheners, hair spray or other aerosols near the alarm.
5. Do not paint the unit. Paint will seal the vents and interfere with the sensor's
ability to detect smoke or CO. Never attempt to disassemble the unit or clean
inside. Doing so will void your warranty.
6. When removed, place the smoke/CO alarm back in its proper location as soon as
possible, to assure continuous protection from fire or carbon monoxide poisoning.
7. When household cleaning supplies or similar contaminants are used, the area
should be ventilated.
 „ 
1. Don’t panic; stay calm. Follow your family’s escape plan.
2. Get out of the house as quickly as possible. Don’t stop to get dressed or collect
anything.
‚ „
WARNING!
1. DO NOT DEACTIVATE THE ALARM UNIT UNTIL THE END-OF-LIFE SIGNAL HAS BEEN
HEARD.
2. ONCE THE MAXIMUM LIFETIME (10 YEARS) IS REACHED, THE ALARM DELIVERS 2
BEEPS EVERY 30 SECONDS.
3. ONCE THE ALARM IS DEACTIVATED, IT WILL NO LONGER FUNCTION. IT CANNOT
BE REACTIVATED AND MUST BE REPLACED.
 ‚ „
Pressing the Test/Silence button can silence the end-of-life signal for up to 3 days.
1. Peel back the shaded label obstructing the "DIS" setting, and break the thin
plastic guard, as below.
2. Twist the plastic pin upwards to the “DIS” position or insert a screwdriver into the
slot and turn the dial clockwise to the “DIS” position.
3. Dispose of the alarm.
4. Replace the alarm.
23 22