X-D50
For power wiring, see page 4
For High or low level input wiring, see page 5
7
Filter settings Sub channel
Speaker wiring X-D50
+ -
Filter settings Front & rear channels
The
low pass filter
is used for
subwoofers. It will allow low
frequencies only and blocks
higher frequencies.
A typical setting is
50 – 70
Hz.
LPF
30 Hz
150 Hz
60 Hz
100 Hz
The
phase control
can be set
continuously from 0 - 180
degrees.
This function is used together
with subwoofers. This is very
useful when you want to adjust
the bass sound for best front
stage image. Start at 0 and turn
the control slowly clockwise
until you experience that the
bass sound is coming from the
front. If you don’t get the result
you want, also try to phase
reverse the subwoofer
connections and make a new
adjustment.
Phase
0
180
o
2. One or two subwoofers to mono sub channel,
Each speaker min 4 ohm.
The high pass filter
blocks
very low
frequencies from reaching
the speakers. It is mostly
used at say 60 Hz to
protect small speakers (
like 6 inch and smaller )
from deep bass.
Set the filter to 15 Hz po-
sition if you want to run the
amplifier in full range
mode (almost).
The filter can not be
switched off.
Crossover
15 Hz
250 Hz
50 Hz
100 Hz
- Front Speaker - - Rear Speaker -
1. Two or four fullrange speakers to the front
and rear speaker channels
+
L
- +
R
-
+
L
- +
R
-
