This model include
- Digital class D technique
- High efficiency
- Low profile design
- RCA line inputs
- Parallel input switch
- High level input with Auto start
- Phase shift control on mono channel
- Powerful cable terminals
- Built-in active crossovers
Installation
Before you begin installation
Before you begin you need to read the manual, to have
some tools, cables and other material available. There
is one such list of material on the following page.
Amplifier location
Important
Allow air circulation around the amplifier.
2
Disconnect Battery
Before starting the instal-
lation, always disconnect
the negative terminal of
the battery.
The X-program series of amplifiers have a compact
design that allows great flexibility in mounting. You
can mount it under a seat or in the trunk.
When you select a location, do remember that the
amplifier generates a lot of heat.
Choose a location where air can circulate freely
around the amplifier. Do not cover the amplifier with
carpets or hide behind trim panels.
Do not mount the amplifier in an inverted or upside
down position.
Check all locations and placements carefully before
making any cuts, drilling any holes or making any
connections.
X-logo on amplifier cooling flange
The X-logo on the amplifier top is attached with
two 1 mm hex. screws. The logo can be removed
and twisted 90 or 180 degrees, and then screwed
back in wanted position. The logo can be mounted
in four different ways to match your installation.
Mounting
Fasten the amplifier to the surface using the four
separate brackets coming with the amplifier. The
brackets are attached to the amplifier with screws
and can be directed in two ways, see figure:
Mount the flanges this way, or this way.
Bottom plate of amplifier
