X-D11
Bridging two amplifiers
Remote bass
boost control.
To Remote on
head unit
GROUND
Battery
Fuse
Distribu-
tion block
Power Cap
You can connect t two X-D11 in
bridge mode.
One of the amplifiers is ”Master”
that controls the signal to the
second amplifier that should be
used in ”Slave” position. The sig-
nal is fed through the Data link
connector. Connect the
amplifiers as in the drawings
below.
Master slave selector & Data link
connection
Data
Link
From line output
of head unit
Bridged
mode
Master
Slave
Bridged
mode
Master
Slave
Bridged
mode
Master
Slave
Bridged switch:
Slave position
Bridged switch:
Master position
Connection of DC-input (to both amplifiers) and Remote sub level
control (to Master amplifier).
7
Connecting two X-D11 in bridge mode will double
the output power. Minimum speaker load is then 2
ohms. The output power with a 4 ohm load is 1500
Watts, and with 2 ohm load 2000 Watts. The RCA
signal must be connected only to the amplifer set
to run as ”Master”.
- The filters as well as the level control is only
working on the ”Master” amplifier.
- Bridging two amplifiers can be done only
between amplifiers of the same model.
Modular 4-pole cable to connect
between Data Link sockets
Speaker impedance: 4 ohm/2 ohm
130.com.ua
Autogood products «130»
