X-POWER XP-12, Руководство пользователя

Страница: 10 / 19

Rev.081022 Page 10 of 19 FUS-20852000-0006
Function
：
1. Connect Remote to Control Pack or activate the Wireless. Press and hold the WIRELESS button
until the BLUE LED illuminates (approximately 3 seconds) to indicate wireless is active.
2.
Press the “IN” button to Power-In winch rope. Press the “OUT” button to Power-Out winch rope.
3. Check Status lights on transmitter periodically while winching. The wireless control will turn off
automatically after 10 minutes of inactivity. The BLUE LED for wireless will flash slowly when the
transmitter battery is low.
NOTICE
To maximize the life of the remote, store the remote in the vehicle and keep it away from oil or water.
Charge the remote at least once every six months to maximize the life of the battery.
METHOD FOR PAIRING WIRELESS REMOTE CONTROL TO WINCH:
1. Disconnect the 12v power supply to the winch.
2. Turn on the wireless mode for the remote control by holding the wireless button for 3
seconds, until the blue LED flashes, then release the wireless button.
3. Now press and hold both the IN and OUT buttons at the same time. All three LED lights will
now flash at the same time.
4. At this time, restore the power connection to the winch.
5. Wait until the three LED lights on the remote control quit flashing and stay on, then release
the IN and OUT buttons.
6. Once the blue LED stays on, the pairing is complete.
7. If pairing fails, disconnect the power to the winch, wait 15 minutes, and repeat the above
operation.
BLUE LED Light
Light on when wireless control is active
GREEN LED Light
Light on when Power-In
POWER-OUT Button
Activates winch to extend rope
GREEN LED Light
Light on when Power-Out
FLASHLIGHT Button
Activates/Deactivates flashlight
POWER-IN Button
Activates winch to retract rope
WIRELESS Button
Activates wireless control of winch
USB Charging Port
Open cover to attach USB C cable