By pressing the button
the motheboard starts the motor performing the parameters auto-
learning.
If the procedure is successfully completed, then the motor keeps running, otherwise the control panel
returns back to its initial state with the four flashing leds.
ENGLISH
13
5. PROGRAMMING
5.1 Trimmer adjustments
OFF
30
90
180
60
120
150
WAITING FILL
ATTESA RIEMPIM.
When it is set to
OFF
, in case of lack of water the motherboard stops the pump and it won’t start until a
manual reset is performed. Instead by setting a value (in minutes) the motherboard will work with the
automatic reset function.
With panel switched off it is possible to define its behavior by adjusting the
WAITING FILL
trimmer:
Each time the motherboard detects the lack of water, it stops the motor and starts a waiting time called
WAITING FILL
, after which the motherboard starts the motor again.
It is always possible to manually reset the panel during the waiting fill time by pressing .
It allows the motherboard to automatically set the values of
MAXIMUM CURRENT
,
MINIMUM
CURRENT
and
MINIMUM COSφ.
To operate the
TOP DRY
is essential to power on the panel and perform the
AUTOLEARNING
.
5.2 Autolearning
After powering on, wait for the following leds flashing:
