- 23 -
B) Manually rotate upward the
visor supports on the side
mechanisms till they reach
their maximum open position
on both sides of the helmet.
(Fig. 7).
1.5.1 - Set the end part of the
visor onto a visor hooking pin
and line up its inner guides
with the mechanism supports
(fig. 8).
1.5.2 - Push the visor inside
onto the hooking pin and line
up the inner guides with the
mechanism supports at the
same time (Fig. 9).
1.5.3 - Push the visor back-
wards, sliding it on the support
until the locking pin clicks in the
hole of the visor and locks it.
1.5.4 - Repeat the steps 1.5.1,
1.5.2 and 1.5.3 on the other
side of the helmet.
1.5.5 - Pull down the visor (see
1.2) then pull it up again (see
1.1) to make sure that the sys-
tem works correctly.
Warning !
Do not loosen the adjusting screws on the hooking
pins of the visor.
7
8
9
