Network Video Recorder Start Guide Ver1.0
13
/
16
Button introduction
:
Refresh current device list
Modify the device IP (valid only for IP address), this option is gray when
selected as UID
Click to add page manually
There are multiple protocols inside. When adding, user needs to select the
corresponding protocol.
After select, the added device will not be displayed. After canceling the
option, the added device can be searched and added again.
Add all searched devices
Only add the selected device (white box before the serial number)
The device can be previewed after added
:
The network disconnection prompt will appear if the camera password or camera information is
incorrect.
The screen will be displayed when the camera is working, the NVR is recording with a hard disk,
and the blue dot is displayed in the upper right corner.
The white screen shows the NVR logo means there is no camera be added.
Note:
When the channel notices the network is disconnected, please check the camera IP and NVR IP
address are on the same network or no, and the account and password are correct or no.
When the camera cannot be found, please check the camera IP and NVR IP address are on the same
network segments. The ONVIF camera cannot be searched across segments.
The IP address of the NVR should not conflict with other devices in the LAN.