Copyright © 2015 WyreStorm Technologies |
TX-SW-IW-0201 Quickstart Guide | 150828
North America: 518-289-1294 | EMEA/ROW: 44 (0) 1793 230 343
3 of 4
Wiring and Connections
HDBaseT Wiring
Wiring for HDBaseT follows the EIA T568B standard.
IMPORTANT! Wiring Guidelines
• The use of patch panels, wall plates, cable extenders, kinks in cables,
and electrical or environmental interference can have an adverse effect
on HDBaseT transmission limiting performance. Steps should be taken
to minimize these factors (or remove completely) during installation for
best results.
• While similar in nature, the HDBaseT protocol is different than Ethernet
and voltages provided for PoH can be higher than those provided by
PoE. For this reason, never connect an HDBaseT link to an Ethernet
router or switch to avoid damaging the connected devices.
Supported Video Resolutions
The type of category cable used and the distance between the transmitter
and receiver can restrict the available video resolution.
Cable Type
Range
Supported Resolution
Cat5/5e/6
100m/328ft
1080p @ 60Hz 36bit
70m/230ft
3840 x 2160 @ 30Hz 4:4:4
Cat6a
100m/328ft
1080p @ 60Hz 36bit
1080p @ 60Hz 48bit
1080p @ 60Hz 3D
3840 x 2160 @ 30Hz 4:4:4
Note: When connected to a class B HDBaseT receiver, the
supported resolution is limited to 70m/230ft 1080p.
IR Wiring
Connection for an IR emitter or cable to control the local source use a
2-pin Screw Down Phoenix connector.
RS-232 Wiring
Connection for RS-232 pass-through to the display at the remote
location uses a 3-pin Screw Down Phoenix connector. The connector
type and pinout on the control system may vary, refer to the 3rd party
manufacturer’s instructions for details.
Power Supply Wiring
Power for the TX-IW-70-POH is supplied via PoH when connected to a
compatible HDBaseT receiver
When PoH is not available from the connected receiver, connect a 12V
DC 1A power supply (not included) using a 2-pin Screw Down Phoenix
Connector.
EDID Settings
EDID can be configured to resolve issues with video output on displays
that may not accept the maximum resolution available from the source.
Remove the faceplate from the TX-SW-IW-0201 and set the switches
based on the table below.
Pin 1 Pin 8
RJ-45 Connector (Gold Pins Facing Up)
Pin 2: Orange
Green
Pin 6:
Pin 1: White/Orange
Pin 5: White/Blue
Pin 3: White/Green
Pin 7: White/Brown
Pin 4: Blue
Pin 8: Brown
1920x1080 (default)
1280x720
1280x800
1024x768
1920x1200
800x600
