Front Panel
Rear Panel
Power In
5.5mm Male Barrel Jack
Connection to this jack is not required when using PoH. See
HDBT In
8-pin RJ-45 female
Connect to the
HDBT Out
of a matrix or HDBaseT transmitter. See
for important wiring
guidelines.
S/PDIF In
TOSLINK (Digital Optical)
Connect to the S/PDIF audio output of the display when ARC is not supported. See
HDMI Out
19-pin type A HDMI female:
Supports HDMI and DVI/D (requires adapter-not included).
S/PDIF Out
RCA Female (Digital Coax)
TOSLINK (Digital Optical)
Outputs audio signal from local source or ARC audio from remote display.
Ethernet
8-pin RJ-45 female | 10/100 Mbps auto-negotiating
Connect to the Ethernet port on a network enabled display.
IR TX/RX
IR TX
- 3.5mm (1/8in) Mono Jack:
Connect to the supplied IR emitter to control a local device from the remote display location via HDBaseT.
IR RX
- 3.5mm (1/8in) Stereo Jack:
Connect to the supplied IR receiver to send IR to the remote display via HDBaseT.
See
.
RS-232
3-pin Phoenix Connector
Used to send and receive RS-232 signals to/from the source location via HDBaseT and firmware updates.
See
.
RS-232
Switches the mode for the RS-232 port.
Normal:
RS-232 HDBaseT pass-through.
Update:
RS-232 firmware update.
Audio Return
Input
Selects the input (HDMI or S/PDIF In) to use for returning audio back to the matrix/transmitter.
See
.
Power LED
Solid:
The receiver is powered On
Off
: The receiver is powered Off
Status LED
Flashing:
The receiver is operating normally.
Off:
The receiver is Not operating normally.
HDCP LED
Solid:
Audio and Video signal is HDCP protected.
Flashing:
Audio and Video signal is not HDCP protected.
Off:
No Audio and Video signal.
LINK LED
Solid:
Link to receiver has been established.
Flashing:
Link to receiver has not been established.
Copyright © 2016 WyreStorm Technologies |
RX-70-4K-ARC v2 Quickstart Guide | 161006
North America: 518-289-1294 | EMEA/ROW: 44 (0) 1793 230 343
2 of 4
