Front Panel
Rear Panel
RS-232 Mode
Switches the mode for the RS-232 port.
Normal:
RS-232 HDBaseT pass-through.
Update:
RS-232 firmware update.
Power LED
Solid:
The transmitter is powered On
Off:
The transmitter is powered Off
Status LED
Flashing:
The transmitter is operating normally.
Off:
The transmitter is Not operating normally.
HDCP LED
Solid:
Audio and Video signal is HDCP protected.
Flashing:
Audio and Video signal is not HDCP protected.
Off:
No Audio and Video signal.
LINK LED
Solid:
Link to receiver has been established.
Flashing:
Link to receiver has not been established.
Power In
5.5mm Male Barrel Jack
Connect to a 12V DC 1.5A power supply. DO NOT connect is using PoH from the matrix.
HDBT In
8-pin RJ-45 female
Connect to an HDBT Out on the matrix.
See
HDMI/HDBaseT Wiring.
HDMI Out
19-pin type A HDMI female:
Supports HDMI and DVI/D (requires adapter-not included).
IR TX/RX
3.5mm (1/8in) Mono Plug
IR TX: Connect to an IR emitter to control a local device from the matrix location via HDBaseT.
IR RX: Connect to an IR receiver to send IR to control an external device located near the matrix via HDBaseT.
See
IR Wiring
.
RS-232
3-pin Screw Down Phoenix Connector
Used to send and receive RS-232 signals to/from the source location via HDBaseT and firmware updates. See
RS-232
Wiring
.
Copyright © 2015 WyreStorm Technologies |
wyrestorm.com
MX-0404-HDBT-H2-KIT Quickstart Guide | 160302
North America: 518-289-1294 | EMEA/ROW: 44 (0) 1793 230 343
2 of 4
