Copyright © 2018 WyreStorm Technologies |
EXF-300-H2 Quickstart Guide | 180516
UK: +44 (0) 1793 230 343 | ROW: 844.280.WYRE (9973)
3 of 4
EDID Configuration
This extender uses EDID pass-through from the display to the source. No configuration is required for EDID settings.
Setup and Configuration
RS-232/IR Over Fiber
The EXF-300-H2 can transmit RS-232 or IR over fiber bidirectionally, however it
can only send one or the other. The following settings must be made on both
the TX and RX for the type of signal that will be sent within the installation.
Send and Receive RS-232
Send and Receive IR
Troubleshooting
No or Poor-Quality Picture (snow or noisy image)
• Verify that power is being supplied to the transmitter and receiver.
• Verify that the fiber cable is properly terminated.
• Verify that the output resolution of the source and display is supported by
this extender.
• If transmitting 3D or 4K, verify that the HDMI cables used are 3D or 4K rated.
• Verify that all source and fiber connections are not loose and are functioning
properly.
No or Intermittent 3rd party Device Control
• Verify that the RS-232/Ethernet cables are properly terminated.
• Verify that emitters/receivers are compatible with WyreStorm IR.
• If using an IR control system, verify that it is connected using the
