Wyrestorm EX-SW-0201-4K, Быстрый старт

Страница: 2 / 4

Copyright © 2015 WyreStorm Technologies | wyrestorm.com
EX-SW-0201-4K Quickstart Guide | 160516
North America: 518-289-1294 | EMEA/ROW: 44 (0) 1793 230 343
support@wyrestorm.com
2 of 4
Front Panel (TX/RX)
EX-SW-0201-4K TX EX-SW-0201-4K TX
EX-SW-0201-4K RX EX-SW-0201-4K RX
Rear Panel (TX/RX)
Set
3 Position Dipswitch:
Used to enables/disable long cable mode,
configure RS-232 port, and configure USB
mode. See RS-232 and Distance Settings
EDID Settings (TX
Only)
3 Position Dipswitch:
Used to set EDIDs to correct resolution
conflicts between the source and the
display. See EDID Settings.
Power LED
Solid: The transmitter is powered On
Off: The transmitter is powered Off
Status LED
Flashing: The transmitter is operating
normally.
Off: The transmitter is Not operating
normally.
HDCP LED
Solid: Audio and Video signal is HDCP
protected.
Flashing: Audio and Video signal is not
HDCP protected.
Off: No Audio and Video signal.
Link LED
Solid: Link to receiver has been
established.
Flashing: Link to receiver has not been
established.
Ethernet
8-pin RJ-45 female | 10/100 Mbps auto-
negotiating
Connect to a Local Area Network or
network device for Ethernet pass-through
over HDBaseT.
RS-232
3-pin Screw Down Phoenix Connector
Used to send and receive RS-232 signals
to/from the source location via HDBaseT
and firmware updates. See RS-232 Wiring .
IR RX/TX
3.5mm (1/8in) Mono Plug
IR TX: Connect to the supplied IR emitter.
IR RX: Connect to the supplied IR receiver.
See
IR Wiring .
Power In
5.5mm Male Barrel Jack
Connect to the included 12V DC 2A
power supply. Only connect to either the
transmitter or receiver when using PoH.
HDBT Out (TX)
HDBT In (RX)
8-pin RJ-45 female
Connect the transmitter
HDBT Out to
receiver HDBT In using the cable created
in Pre Wire step 1.
HDMI In (TX)
HDMI Out (RX)
19-pin type A HDMI female digital video/
audio: Supports HDMI and DVI/D (requires
adapter-not included). Limited to 297MHz
pixel clock
VGA In (TX Only)
15-pin VGA VESA (D-SUB 15):
Connect to D-SUB 15 VGA output of a
device such as a computer.
15-pin VGA cable is required.
Audio In (TX)
Audio Out (RX)
3.5mm (1/8in) Stereo Jack
In: Connect to the analog audio output of
a device to send audio over HDBaseT.
Out: Connect to an analog audio input
of a device to play audio received over
HDBaseT.