Front Panel (TX/RX)
Rear Panel (TX/RX)
Power LED
Solid:
The receiver is powered On
Off:
The receiver is powered Off
Status LED
Flashing:
The receiver is operating normally.
Off:
The receiver is Not operating normally.
HDCP LED
Solid:
HDCP content is present.
Flashing:
HDCP content is not present.
Off:
No signal.
LINK LED
Solid:
Link to receiver has been established.
Flashing:
Link to receiver has not been
established.
RS-232 Mode
Switches the mode for the RS-232 port.
Normal:
RS-232 HDBaseT pass-through.
Update:
RS-232 firmware update.
Power In
5.5mm Screw Down Barrel Jack
Connect to the included 18V DC 1A power
supply. to the transmitter. A power supply
is not required on the receiver as it will be
powered using PoH. See
for important information.
HDBT Out (TX)
HDBT In (RX)
8-pin RJ-45 female
Connect the transmitter
HDBT Out
to receiver
HDBT In.
See
IR TX/RX
3.5mm (1/8in) Mono Plug
IR TX
- Connect to the supplied IR emitter to
control a local device from the remote display
location via HDBaseT.
IR RX
- Connect to the supplied IR receiver to
send IR to the remote display via HDBaseT.
See
RS-232
3-pin Screw Down Phoenix Connector
Used to send and receive RS-232 signals
to/from the source location via HDBaseT and
firmware updates. See
.
HDMI In (TX)
HDMI Out (RX)
19-pin type A HDMI female digital video/
audio: Supports HDMI and DVI/D (requires
adapter - not included). Limited to 297MHz
pixel clock
Copyright © 2016 WyreStorm Technologies |
EX-35-H2 Quickstart Guide | 161102
North America: 518-289-1294 | EMEA/ROW: 44 (0) 1793 230 343
2 of 4
EX-35-H2 Transmitter
EX-35-H2 Receiver
A B C
D
E
EX-35-H2 Transmitter
EX-35-H2 Receiver
A
B
C
D
E
