Power Unit Assembly
Page 8
February 2016
SCR-UM-00364-EN-02
Throttle Assembly
Figure 6: Throttle assembly location
1� Place the throttle lever on the left handle just below the hand grip�
2� Position the lever so it clears the handle guard in all positions�
3� Place the lever ring clamp around the handle bar and tighten with a flathead
screwdriver and adjustable pliers�
4� Use the zip ties provided to keep the throttle cable tight to the handle bars�
5� Check to make sure the cable stop for the throttle adjustment cable is fully seated into
the throttle adjustment linkage on the carburetor� Make sure the metal cable stop is
completely inside the throttle adjustment linkage, as shown below�
Correct
Figure 7: Throttle assembly detail
a� If the cable stop is not fully seated, loosen the throttle control adjustment
screw and grab the end of the adjustment cable with the slip joint pliers�
6� Pull gently on the cable until the cable stop is completely within the throttle
adjustment linkage�
