2-2 Attach the Top Facia Stiffener to the Top Facia using glue and 1 ¼” nails. Nail from the inside. Make sure
banded edge is down. Note: make sure the pockets are facing toward the back. You will use those pockets
during the installation step. This will be ¾” off the sides.
Figure 2-2
2-3 Attach the Top Rear Stiffener (F-1) to the back using glue and 1 ¼” nails. Make sure the banded edge is
down and the pockets are facing toward the back. This will be ¾” off each side as in the previous two steps.
Figure 2-3
2-4 Add the Top Cleats (K) to the Top Panel in between the Top Rear Stiffener and the Top Facia Stiffener
using glue and 1 ½” screws.
Figure 2-3
Your header is now complete!