Step 7: Install the Bed Face Panel Unit
Figure 7-1
7-1 Lay the Bed Face Panels down on a non-scratch surface such as a carpet or blanket.
7-2: Completely assemble the 4 Frame Sections with the corner brackets and the 3/16”x1/2” (M5x12mm) black
bolts provided. Refer to Drawing 17 below to properly place the leg stops at outer right and left bottom holes at
the foot of the bed frame.
7-3: Position the bed frame on the bed face panels. With the Head Frame section flush with the head end of
the Bed Face Panels. Refer to Figure 7-1. Carefully attach the Bed Frame so it is centered on the Bed Face
Panels; you will have approximately 1” (25mm) space from the bed frame to the panel edges right and
left and at the bed foot.
Note: It is very important to have the Bed Frame centered on the Bed Face Panels.
Any error will be noticed in the vertical sight lines when the bed is closed.
7-4: Three steel stiffeners are provided for all beds (5 for King). These notched stiffeners should be located
and attached to divide the Bed Face length into four Sections. Locate them approximately 1 ½” from the seam
of each pane. This will leave room for the Panel Connectors (J). Use caution not to damage raised panels by
putting screws in recessed areas.