Würth WDM5-12
20
EN
Message Codes
If the message
Error
does not disappear after
switching on the device repeatedly, contact the
dealer.
If the info icon appears with a number, press
the Clear button and observe the following
instructions:
Care
•
Clean the device with a damp, soft cloth.
•
Never immerse the device in water.
•
Never use aggressive cleaning agents or
solvents.
Warranty
For this Würth tool, we provide a warranty in
accordance with statutory/country-specific
regulations from the date of purchase (proof of
purchase by invoice or delivery note). Damage
that has occurred will be corrected by replace-
ment or repair. Damage caused by normal
wear, overloading or improper handling is
excluded from the warranty. Claims can only
be accepted if the power tool is sent undisas-
sembled to a Würth branch office, your Würth
sales representative or a customer service
agent for Würth compressed-air and power
tools.
No.
Cause
Correction
156
Transverse tilt greater
than 10°
Hold the instrument without
any transverse tilt.
162
Calibration mistake
Make sure, the device is
placed on a absolutely hori-
zontal and flat surface.
Repeat the calibration
procedure. If the mistake
still occurs, contact your
dealer.
204
Calculation error
Perform measurement
again.
252
Temperature too high
Let device cool down.
253
Temperature too low
Warm device up.
255
Received signal too
weak, measuring time
too long
Change target surface (e.g.
white paper).
256
Received signal too
high
Change target surface (e.g.
white paper).
257
Too much background
light
Shadow target area.
258
Measurement outside
of measuring range
Correct range.
260
Laser beam interrupted Repeat measurement.
