19
3. How to install and remove the flexible
grinding stone
You can use the same wheel nut and wheel washer that
used for the grinding stone.
1) Set the wheel washer of the spindle as the installing of
the grinding stone. And then, set the pad and flexible
grinding stone one by one.
2) Set the wheel nut to the spindle above the flexible
grinding stone.
3) Fix the axis of the spindle by pressing the lock pin. And
then, fasten the wheel nut with a spanner tightly.
4) Do the same process reversibly to remove the sanding
disc.
1. Avoid excessive pressure on the grinding
stone
Avoid excessive pressure on the grinding stone.
Grinding is done by tool's weight. Apply the grinding
stone lightly to the work.
Excessive pressure on the grinding stone will decrease
grinding speed and cause rough finishing surface. Also,
it may cause overheating and motor failure.
2. Applications
To do finishing work and removing splinters of iron,
bronze, aluminum, cast.
To grind of welding section part and removing rust.
To do finishing work for the surface of synthetic resin,
slate, brick and marble.
To groove and cut tile and stone.
1. How to install and remove the Grinding Stone
Always turn off the switch and
disconnect the plug from the power
supply before
installing and removing
grinding stone. Never use the grinding
stone below the peripheral velocity (See
to specifications).
Installing and Removing
1) Place the spindle upwards. Insert the depressed part of
the wheel washer onto the plane part of the spindle.
2) Place the prominent part of the grinding stone onto the
wheel washer.
3) Set the wheel nut onto the spindle over the grinding
stone by a screw.
4) Insert the lock pin in the gear cover, then fasten the
wheel nut with the spanner.
Warning
You must install the wheel guard and
wear the safety goggles during using of
the disc grinder with the special parts.
2. How to install and remove the sanding disc
Do not use the wheel washer and wheel nut for the
grinding stone. Please use other washer nut for the
sanding disc.
1) Set the rubber pad and sanding disc to the spindle.
2) Set the washer nut to the spindle above the sanding disc.
3) Fix the spindle by pressing the lock pin with fingers. And
then, fasten the washer nut with a spanner tightly.
4) Do the same process reversibly to remove
the sanding disc.
Operating Instructions
Spanner
Fastening
Projection
Lock pin
Wheel
guard
Wheel
washer
Grinding
stone
Wheel nut
Spindle
Spanner
Spanner
Fastening
Fastening
Sanding
disc
Flexibile
grinding stone
Rubber
pad
Pad
Lock pin
Lock pin
Washer
nut
Wheel
washer
Wheel
nut
Содержание EAG 20-230
Страница 2: ...2 DE 3 12 GB 13 21 GR 22 32 HR 33 41 BiH 33 41 RS 42 50 ME 42 50 bg 51 62 Ro 63 72 SI 73 83 AL 84 92 ...
Страница 93: ...93 ...
Страница 94: ...94 ...
Страница 95: ...95 ...