W-LINK-CAN
Product information
W-LINK-CAN_V1.70_PI_2018-08_EN Subject to technical changes
Page 3 of 4
3
Installation
Fig. 1 Wall or ceiling installation, drilling dimensions in mm
Wall or ceiling installation
1. Insert a flat screwdriver into the opening
slit
(A)
and open both
housing panels
(B)
.
2. Refer to the drilling dimensions of the
four mounting holes
(C)
and install the
housing on the wall or ceiling.
Access to connections, coding
switch and LEDs
1. Loosen the four screws
(D)
.
2. Open the housing.
(
→
Chapter 4 "Connections" on page 4)
Fig. 2 Wall installation
Fig. 3 Ceiling installation
Adjusting the antenna
In order to receive a uniform signal, always
place the antenna rod vertically.
•
For wall installation:
place the antenna
rod vertically. (
→
Fig. 2)
•
For ceiling installation:
fold the antenna
rod vertically. (
→
Fig. 3)
Fig. 4 Setting up the receiver and transmitter
Setting up the receiver and
transmitter
The range of radio waves in the wall area
and in the vicinity of existing objects is
influenced by disruptive scattering or
reflection. To avoid this, install the receiver
and transmitter as follows:
•
Do not
install on the same wall side in
order to avoid radio propagation along a
wall surface
• Install on opposite or adjoining wall
surfaces (
→
• Install the receiver with a
distance of at
least 50cm
to other transmitters and
high-frequency sources of interference
such as GSM, DECT, wireless LAN or
computer, audio and video systems
•
Tip:
Improve reception by moving the
transmitter and receiver
Note!
•
Further installation instructions can be found in the W-LINKpro System Description.
