7
o
JA.
""-
1PER ADJ1JSTM.Elr:1
The dampers are adjusted by the da.mp(::r· ]ever lif-i d.owel.
which protrudes through the damper lever�� �ee F�g. 700-Lu
'1foen the key is fully depressed
.7
the darr.per should be 1 i h:ed
3 / 16" from the reedo Turning the slotted dowel c0
1
rnter-clock:w1 �e
ca uses the damper to be lifted higher.
When the damper link (Item 19, Page 700-9
c
) is depressed,
all the dampers lift from the reeds at once
e
(See Fig. 700-Q.}
This should be followed if it is ever necessarf to remove the
reed bar.
TONE REGUIATING (OR VOICING)
Tone regulating of the Wurlitzer Electronic Piano is accomplished
in the same.manner as in a conventional piano and should only be done
by a tuner-technician.
STRIKING POINT
The striking point of the hammers to the bar is very important,
just as it is in a conventional piano
s
The striking point is properly
set at the factory and should require little or no adjustment in the
field.
In the event the striking point does need adjustment, it is more
likely to be in the treblec If some of the treble notes sound "dead"
or nwoody
n
, first check to be sµre the two large bar mounting screws
are not down tight against the rubber mounting washers
#
(see
Fig. 700-G.)
Thenr8move the rear large screw and loosen the frunt one. Turn the in
strument on and while striking the treble keys, move the treble end of
the bar slightly forward and backward until the maximum volume and de
sired tone is reached. If this location of the bar is such tha: the
rear
sorew
hole in the bar mounting block does not coincide with the
center of the rear mounting hole in the bar, plug the original hole in
the mounting block and re-drill a hole for the
rear screw.
The front
mounting hole in the bar is slotted and allows for adjustment. Before
puttinq
screws
in
t
be sure the proper washers or
spacers are
in place.
Also remember there should be l/64
n
clearance
between
the heads of the
screws and the rubber mounting
washers.
If there are only one or two treble notes that do not sound right
because
of improper striking point,
the hammers can
be burned
either
in
or out by applying
heat
with
a solderinq
iron to
the shank
or moulding
of the
hammer
g
and at the
same time
forcing the hammer in the
desired
direction. (See Fig. 700-M).
700-18
scanned by tropical fish
tropicalfishvintage.com
Содержание 700
Страница 11: ...700 10 0 0 c scanned by tropical fish tropicalfishvintage com ...
Страница 15: ...700 14 scanned by tropical fish tropicalfishvintage com ...
Страница 16: ... l 0 0 b 700 15 scanned by tropical fish tropicalfishvintage com ...
Страница 33: ......