3
M06
Wunda Pumpset
✆
0800 5420 816
www.wundatrade.co.uk
THE BRAND YOU CAN TRUST
Identify and familiarise yourself with each individual component. Assembly of the pump set and pump is recommended on the bench prior to fitting the complete unit to the manifold.
The use of PTFE tape is not required when the supplied washers are fitted correctly, however if you wish we recommend the use of a liquid PTFE.
First connect the lower pump
holder onto the temperature
control mixer ensuring the correct
washer is located between the two
components.
Select a pump washer (large black washer)
and locate into the lower pump holder/
Wunda temperature control mixer. Again
tighten by hand taking care not to cross the
pump thread.
Select a pump washer (large black washer) and
locate into the top flow elbow & pump holder.
Tighten the pump holder onto the pump by
hand, be careful not to cross the pump thread.
Fit a washer into the lower flow inlet elbow and
screw the elbow onto the left-hand inlet (red
dot) side of the temperature control mixer.
1
2
3
4
Revision date: 25/4/2018
