MISCOM7212G Series Industrial Ethernet Switch
- 7 -
3-wire RS-232.
Serial communication parameters are as follows:
Baud Rate: 115200bps, Data bits: 8 ,Parity: none, stop bit: 1 Flow Control:
none
2.2. Hardware Installation
2.2.1. Installation notice
The Industrial Ethernet switch is used standard 35mm DIN-Rail
install.Please make sure a suitable work environment, including power
requirements, enough space, connect equipment and other equipment status.
Please confirm the following installation requirements:
Power supply: Standard DC24V power supply
Environmental requirements: Temperature -40°C ~ 70°C, relative
humidity 0 ~ 95% (no condensation).
Grounding resistance requirement:<5
Configuration requirements under the contract, check the cable is in
place, fiber optic connectors is appropriate.
Avoid direct sunlight and away
from heat sources or areas with strong
electromagnetic interference.
Standard 35mm DIN-rail installation. Check for suitable cables and
connectors.
Attention
Before installing or connecting Ethernet switch please make ensure that
disconnect the power line. Do not exceed Max. current. If exceeds the
maximum current, make the wire overheat, causing serious damage to the
equipment.
Separate the power cable and other cables, if the two paths must cross,
must ensure that the intersection of these lines are vertical.
Grounding and cabling can effectively suppress the noise caused by
electromagnetic interference. Before connect the switch with equipment
please connect GND first. Connected to the grounding screw from the
ground surface.