WTI IPS-15, Руководство пользователя

Страница: 22 / 56

c) When addresses are assigned to a series of IPS Satellite
Units, all satellites that share a specific address (for
example "2"), are considered to be part of the same
"Zone." For example, if your application includes three
satellite units whose Address Selector Switches are set at
"2", then those three Satellite units would all be part of
"Zone 2", and any commands directed to Zone 2 would be
applied to those three satellite units.
d) For more information on Satellite Addresses and Zones,
please refer to Section 6.1.
Notes:
·
The Master Unit will not recognize Satellite Units
that are connected while the Master Unit is powered
up, until the Master Unit has been powered off
and on.
·
If you attempt to address a command to a Satellite
Unit that was connected after Power Up, the IPS-15
Plug Status Screen will indicate that the Satellite Unit
is not recognized.
·
After connecting Satellite Units to the IPS-15 Master
Unit, use the Master Power Switch on the Master
Unit's back panel to power the Master Unit Off, and
then Back on again. This will allow the Master Unit
to recognize all newly connected Satellite units.
This completes the IPS-15 installation instructions. Please proceed
to the next Section for instructions regarding unit configuration.
4-4
IPS Internet Power Switch; User's Guide