WTC MedWeld 3005, Руководство оператора

Страница: 104 / 206

GU\TCSXUTe\Uc
$" =UTGU\T# %?`UbQd_bµc7eYTUD)## "
= #" "%1`bY\" "
described on page 5-10.
3QedY_^*
DXYcVe^SdY_^Yc^_dTUcYW^UTV_becUY^Q^_b]Q\
`b_TeSdY_^be^9dYcY^dU^TUTV_bc`USYQ\cYdeQdY_^c
ceSXQcdUQbT_g^gXYSXbUaeYbUS_^dY^e_ec
TQdQS_\\USdY_^
>?D5*
There must be a MINIMUM of 5 cycles delay programmed after turning
ON any CONTACTOR SELECT prior to any weld current statement.
$QDORJ3UHVVXUH
&RQWURO)XQFWLRQV
Programs #T-93300-19 and greater will support analog I/O
through an analog card in the SLC rack. To implement this
support, four new functions have been added to this version. For
all these functions, pressure channel #1 corresponds to the SLC
Analog card channel #0. Pressure channel #2 corresponds to
Analog channel #1.
08 SET VALVE n CYLINDER RESSURE TO mm PSI
(n = 1,2; m = 0–99)
This function sets the final pressure that the cylinder for
either weld gun must achieve before welding begins.
n is the weld gun number, either 1 or 2. Set the final pressure
mm in the range 0 – 99 PSI.
09 WAIT nn CYCLES FOR PRESSURE ACHIEVED
(nn = 0–99)
This function tells the control to pause in a weld sequence
until it detects that the valve pressure programmed (in
Functions #08, #13 and #14) has been achieved.
Set the number of cycles nn in the range 0 – 99.
If more than one valve pressure setting is in a sequence, this
function monitors only the last pressure function it sees.
If the valve pressure is not achieved after the programmed
number of cycles, the control generates a PRESSURE NOT
ACHIEVED condition. If the Pressure Not Achieved setup