WRIGHT QUAD W-1904, Руководство пользователя

Страница: 13 / 52

RIGHT ACHINE
W-1904 QUAD DUAL SIDE GRINDER
Revised 10-30-98
12
LOADING SAW
SET UP (CONTINUED)
4. Tighten Band Saw Hold Down at each end of the Saw Clamp Bar. If too tight the index will not
be able to slide back, and if too loose the band saw will lift up when indexing.
5. After making sure the Index Finger is in the gullet, turn Switch (G) to Run. This will close the
Clamp Jaws. Move Joy Switch (B) to the left until a tooth passes the Index Finger. Then allow Joy
Switch (B) to return to center position.
6. At this time a saw tooth should be against the Index Fingers. If the index stroke is insufficient,
adjust as shown on
page 8.
7. Set Tooth Counter (C) on the number of teeth to be ground.
8. Place Joy Switch (A) in center position, pull Start button.
9. After coolant flow is on tip, place Joy Switch (A) into Automatic #1.
10. The Roughing Head will travel down and grind a tooth. Set speed and stroke as necessary.
11. Adjust In-Feed knobs as necessary on the Roughing Head to leave .005 to .007 per side for
Finish Grind.
12. As the machine cycles the rough ground teeth to the left and the first rough ground tooth
reaches the Index Finger, shift Joy Switch (A) to Automatic #2. This will start the Finish Head
cycling.
13. Adjust In-Feed knobs as necessary to obtain finish kerf width. Set speed and stroke as
necessary.