OPERATION INSTRUCTIONS
1. PREPARE
1.1 Use super high pressure hose to do connect the high pressure outlet of the pump and the high
pressure outlet of the bolt Tensioner. Insert the quick coupler till to the end, Please besure to
achieve reliable econnection.
1.2 Loosen the pressure regulating valve, then tighten the check valve to show it is
working stage
.
2.1 Put through the current source, turn the circuit breaker of the electrical box shell to “
on” position.
2.2 Hold on the resettable buttons on the line switch, adjust the pressure regulating valve on
2. ADJUSTING THE HIGH PRESSURE
the pump, to
set
the
desired
pressure; then loosen the resettable buttons on the line
switch, Release cut-off valve to show the pressure gauge pointer to zero, retighten the cut
-off valve; pressed the resettable button, observe the pressure gauge pointer, repeat the
above steps, until transferred to the required pressure, lock the nut, complete the process
of the pressure regulation
.
3. OPERATION
3.1 Press on the wire control switch self-locking button, the pump will output the pressure,
hydraulic bolt tensioner will start to work; when the pressure is close to the set value, releas
-e the self-locking button, Press the self resettable button on the control switch; to make the
pressure reaches the desired pressure.
3.2 When the working pressure is same as the set required pressure, press
the
self-locking
on the wire control switch, when gauge pointer stability, read the pump output pressure as
the setting pressure, you may release the button.
3.3 Release cut-off valve so the pressure gauge will drop to zero, retighten the cut-off valve;
Repeating above steps until the whole process is over.
3.4 After the end of the operation, loosen the valve venting in the hose and the pressure in
the hydraulic machinery, remove the high-pressure hose, cover the dustproof cap; turn off
the source, turn the circuit breaker of the electrical box shell to the “off” position.
REMARK:
For initial work or repair, Please run the motor for several times, this will help
remove the air from the high-pressure pump, then normal operation can be used upon the
normal oil.
7
